Depending on the conditions of the network, a firmware update via a
network may take more than one hour or even fail to finish. If the
update is not completed within two hours, turn off the power supply
by pushing the ON/STANDBY button and then try updating again
from the beginning.
Updating the firmware and adjusting the settings will be done
automatically, but may take some time to complete. Please follow
the procedures as instructed when you update. Note that the
update may fail, or cause problems for your A/V receiver, if you do
any of the following:
• Pull out the A/V receiver’s power cord;
• Interrupt the power supply to the A/V receiver (e.g. if the
breaker is tripped or if there is an electrical outage);
• Insert or remove the LAN cable from a device in
your network when updating over a network;
• Insert or remove a USB memory device from the
A/V receiver when updating via USB;
• Operate components connected to the A/V receiver
via HDMI, such as a TV or a recording device.
If your A/V receiver is damaged for any of the reasons above, an
Onkyo service center will repair the unit for a fee.
If you see "No Update" on the front panel immediately after you have
started the firmware update process, you have the latest firmware. In
this case it is not necessary to do this update.
How to upgrade the firmware via Network:
1. If the unit is connected via LAN and there is firmware update available, the
"Firmware Update Available" message may appear. To execute updating,
select "Update Now" with the cursor buttons of the remote controller and
press ENTER. The unit automatically turns itself into standby mode about
30 minutes after "Completed!" appears on the display, and updating will be
complete.
2. Alternatively, to force an update, select “SETUP” on the front panel, then
scroll and select “8.Misc”, “F/W Update” “Update Via NET” and press
ENTER.